Starter Vape Kit spec sheet — with QC photos
There is no shortage of suppliers quoting starter vape kit. The scarce thing is a supplier who will tell you which SKU to drop. We have been shipping starter vape kits long enough to know that the honest answer is usually a shorter list, and that is the answer we give.
Published 05 January 2026 · VapeWholesaleHub · Reading time 8 min
Batch consistency and why it matters
Starter Vape Kit is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.
Compliance without the last-minute scramble
Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Where the margin really sits
Unit price breaks usually land at 300, 800 and 1600 pieces. Between those steps the cost curve flattens, which is why pushing a 200 unit order to 500 often costs less per unit than buyers expect.
We publish a realistic band of 2.94 to 8.54 per unit for standard configurations at 300 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.
- Standing reorder schedule with a fixed cut-off
- Seven-day defect reporting with replace-or-credit
- Specification locked in writing before production starts
- Reference sample retained from every batch
- Artwork proof plus physical dummy for custom packaging
- Mixed SKU cartons to spread first-order risk
The reorder is the real test
Reorders are the real test of a supplier. If the second shipment does not match the first, the relationship is over regardless of price, so we treat the reorder as the actual deliverable.
Returns are handled as data, not as complaints. Every reported failure is logged by mode and by batch, and the pattern is reviewed monthly with the factory.
Specification summary
| Battery | 350 mAh |
| Pod capacity | 2.0 ml |
| Coil resistance | 1.0 ohm |
| Included | Device, 2 pods, cable |
| Charging | USB-C 5V/1A |
| Packaging | Retail box |
| Minimum order | 200 units per SKU, mixed cartons allowed |
| Lead time | 25 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What is the minimum order for starter vape kit?
Standard configurations start at 300 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 800 units because of setup time on the line.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 300 units. We would rather you handle the sample than approve a specification from a photograph.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz